Publicité
Les langues disponibles
Les langues disponibles
Step 6
Make sure all control knobs are OFF,
then remove all control knobs.
Step 7
Tighten screw on each control valve
as shown in Figure 1. Replace control
knobs when finished.
Note:
This screw regulates the low
flame setting for natural gas.
After replacing knobs you will
notice the knobs will stop at the
"MED" setting on the dial. This
is the correct low setting for
natural gas. Do not try to turn
the knob to "LO" setting.
Step 8
Carefully replace each burner, making
sure burner openings slide over valve
nozzles and burner holes are facing up.
Reattach burner screws and hitch pin.
Step 9
Replace warming rack, cooking grills and
heat shields.
Note:
Follow directions in the leak
testing section of this manual
before using this grill.
7
F
1
IGURE
Publicité
