Kasanova MONTALATTE Manuel D'instruction page 11

MILK FROTHER
11
Note: Do not immerse the product in water. Ensure that the connector on the bottom
of the product remains dry.
2. Frothing Milk
1 Connect the power cord plug to a suitable power outlet socket.
2 Open the lid and attach the whisk onto the rotating shaft.
3 Fill in cold milk. The milk level must be between the mark "MIN" and "MAX ".
4 Put the lid on firmly by pushing it down slightly.
5 Place the milk frother on the power base.
6 Switch ON the product and the button will light up. The product will begin frothing.
7 The temperature of milk will reach approx. 65°C around 1 minute and the product
will stop operating when ready. If the frothed milk is not removed and the temperatu-
re of the milk falls below 50°C, the milk frother will start operating again automatical-
ly. You can also press the ON/OFF button to turn OFF the product.
8 Remove the milk frother from the power base and open the lid. Then pour the milk
from the milk frother.
Note: If you want to prepare more milk froth, let the milk frother cool down for a few
minutes before further use. As long as the milk frother is hot, the thermostat preven-
ts it from being used. You can rinse the inside of the milk frother with cold water to
accelerate the cooling process.
3. Heating Milk
1 Connect the power cord plug to a suitable power outlet socket.
2 Open the lid and remove the whisk from the rotating shaft.
3 Fill in cold milk. The milk level must be between the mark "MIN" and "MAX".
4 Put the lid on firmly by pushing it down slightly.
5 Place the milk frother on the power base.
6 Switch ON the product and the button will light up. The product will begin to heat.
7 The temperature of milk will reach approx. 65°C around 1 minute and the product
will stop operating when ready. If the milk is not removed and the temperature of the
milk falls below 50°C, the unit will start operating again automatically. You can also
press the ON/OFF button to turn OFF the product.
8 Remove the milk frother from the power base and open the lid. Then pour the milk
from the milk frother.
4. Boil-dry protection
1 If there is not sufficient milk in the milk frother, it will shut OFF automatically. Ne-
vertheless, always ensure that there is enough milk in the product, as switching the
device OFF automatically can shorten its life span.
2 Allow the product to cool down before filling it again.