Remote Control Unit (Rcu); Connections; Connecting To Tv & Vcr - Zodiac DZR-1900CI plus Manuel D'utilisation

2.3 Remote Control Unit (RCU)

You can start the receiver, operate on-screen menu, and use a variety of key function.
1. STAND BY Turns the receiver On/Off.
2. MUTE Mutes audio output.
3. LEFT/RIGHT (◀ /▶ ) If you press Left/Right button while watching channel, you can adjust Volume level.
If you press Left/Right button on the menu status you can move to Left/Right side.
4. UP/DOWN (▲ /▼ ) Changes channels in the No-menu state and moves up/down in the Menu state.
5. OK Confirms the choice with the highlighted menu item.
While watching TV or listening to Radio you press the OK button, the channel list will appear.
If you press the EXIT button on the final menu state, you can move to the previous menu.
6. MENU Shows the Main menu in No-menu and the TV-Radio program screen in the Menu state.
7. EXIT Exits from the present menu and moves to the previous menu.
8. NUMERIC KEY (0-9) Controls the numerical operation and especially changes program directly.
9. EPG Display the TV/Radio Program Guide.
10. GROUP Make favorite group by satellite, TV, Radio and by your Choice.
11. CH ▲ /CH ▼ Select CH.
12. Pg ▲ /Pg ▼ Move Up/Down a page in the channel list.
13. . VOL ▲ /VOL ▼ Adjust volume level.
14. INFO Shows the information of the current program. If you press the INFO button, the channel info box will
be shown continuously even though the preset time for channel info box elapsed. If you press the INFO or EXIT
button again, the channel info box will be disappeared.
15. SAT/TV Select TV Mode and Set-Top-Box mode.
16. UHF (European Standard) Sets UHF Menu.
17. AUDIO Select Audio Mode as Stereo, Left or Right and Audio Language.
18. PAUSE To pause the Video Screen.
19. RECALL If you press recall button, previous Channel will be shown.

3. CONNECTIONS

· Install the receiver in horizontal position.
·
Do not put any heavy stuff such as a TV on the receiver.
·
Do not install the receiver in the place as follows: Vibrating, direct sunrays, humid place, too high or low
temperature, and no ventilated place.
3.1 Connecting to TV & VCR
Receiver to TV with RF
·
Connect the TV antenna to RF-IN.
·
Connect the RF IN of Receiver to TV-OUT.
·
Connect the Video and Audio of TV to the Video and Audio.
·
Go to section 3.2 Connecting to Dish, then connect your dish.
E - 3
ENGLISH