Publicité
Les langues disponibles
Les langues disponibles
The temperature can be adjusted 1° at a time; adjust the temperature using buttons
or
to the right
of the temperature indicator.
Each time you press the buttons 'upper zone' or 'middle zone' increments of one degree in the selected
area. For a lower temperature than indicated, press repeatedly until the display shows the desired
temperature.
Each time you press the
or
buttons increases or decreases the temperature on lower zone.
After selecting the temperature, the display will flash for 5 seconds, and will display the current
temperature in the wine cellar
NOTE: The default temperature is 7°C for all zones
The temperature range of the upper zone is between 5 ° C and 18 ° C.
The temperature range of the central zone is between 5 ° C and 10 ° C
The temperature range of the lower zone is between 10°C and 18°C
Note : In order to avoid excessive condensation when the ambient temperature is greater than 28°C, do
not set the temperature below 7°C.
Light control
To switch on or off the light inside cabinet, push button n°2
The LED light is appropriate for wine preservation. Nevertheless it is advisable to switch the light off
during normal operation.
NOTE: when first operating the wine, or switching it on after a long period of non-use, the inside
temperature will not immediately be the temperature shown on the temperature indicator; it will take a
few hours before the wine cabinet reaches an evenly distributed temperature.
IMPORTANT: after unplugging, turn off the device or after a power failure; it is imperative to wait
5 minutes before relighting. Otherwise, the wine cellar will not turn on.
52
Publicité
