Publicité
Les langues disponibles
Les langues disponibles
Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside using warm water with a
low concentration of dishwashing liquid. Do not use abrasives or scouring powder; they may scratch the
surface finish.
USAGE
CAUTION! Wine cabinets are intended only for storing and preserving wine.
IMPORTANT: Your wine cabinet is ideally suitable for holding Bordeaux type bottles of 0.75 L capacity. It
can contain larger bottles; however care must be taken that they do not prevent the door from closing
properly.
- When closing the door ensure that it does not touch any of the bottles.
- If you load several bottles at a time, it will take longer before the cabinet reaches the desired
temperature.
-
In order to avoid damaging the door seal, ensure that the door is fully open before moving the racks
along the compartment rails.
Adjusting the temperature
Upper control panel
1 – Stop/start button
2 – Lamp button
3 – Display screen for upper zone
4 – Display screen for middle zone
Lower control panel
7 – Display screen for lower zone
8 – Button for raising temperature on lower zone
9 – Button for raising temperature on lower zone
To switch the wine cabinet on or off, either press button 1.
1
3
2
USAGE
4
5 – Button for raising temperature on upper
zone
6 – Button for raising temperature on middle
zone
8
7
9
5
6
51
Publicité
