Einhell Royal REB 1300 F Mode D'emploi page 12

Anleitung REB 1300_F_SPK1:_
GB
Lay the power cable on the ground in front of the
outlet in a figure 8. Work away from the outlet or
cable and ensure that the power cable always trails
in the hoed soil which will prevent the hoe blades
from traveling over the cable.
8. Maintenance, care and storage
Maintenance and cleaning work on the machine as
well as removal of the safety devices may only be
performed when the motor is switched off and the
power cable has been pulled. Worn out or damaged
hoe blades should only be replaced by an authorized
professional (see address on warranty certificate).
Do not clean the tool with running water - and
particularly not with a pressure hose.
Ensure that all mounting components (i.e. screws,
bolts, nuts etc.) are always tightened so that the
machine can be safely operated at all times.
Store the device in a dry room. All the metal parts
should be cleaned and then oil to ensure that they
provide a long life. For best results, clean the plastic
parts of the machine with a brush or rag. Do not use
any solvents to remove dirt.
For space saving storage undo the star nuts (Fig.
5/Item 8) and fold the bottom push bar (Fig. 5/Item 1)
forward. Ensure that you do not damage the cable.
At the end of the season, perform a general
inspection of the machine and remove any deposits
which may have accumulated. At the start of each
season, ensure that you check the condition of the
machine. If repairs are necessary, please contact
one of our customer service centers (see address on
warranty certificate).
9. Replace the hoe blades
For safety reasons, we recommend having the hoe
blades replaced by an authorized professional (see
address on warranty certificate).
Important!
Wear working gloves. Use only genuine spare parts
since otherwise the function and safety of the
machine cannot be guaranteed.
12
28.09.2007 7:49 Uhr Seite 12
10. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
11. Technical data
Voltage
Power input
Working width
Hoe diameter
Idle speed
Number of blades
L noise level
PA
L peak noise level
WA
Vibration at the handlebars a
230V ~ 50Hz
1300 W
26 cm
23 cm
110 rpm
4 pieces
76 dB(A)
93 dB(A)
≤ 2.5 m/s 2
hv