BorMann PRO BWR5516 Manuel D'utilisation page 2

EN
SAFETY INSTRUCTIONS
Warning: Read the manual carefully before use. Failure to follow the warnings and instructions may result in damage to the machine,
physical injury and/or damage to property. Store the manual in a safe place for future reference.
• Wear safety shoes and gloves.
• Do not insert fingers or feet into the guard net.
• Forbid anyone to be under or near the fork arms when they are in the upper position.
• Do not use the machine as a vehicle jack.
• Do not lift or lower loads that are placed near the edge of the fork arms.
• Do not handle swinging loads.
• Make sure that foodstuffs do not come into direct contact with the fork arms.
• Do not use the machine in explosive atmospheres.
• Before transporting loads with the machine, make sure that its fork arms are in the lowest position.
• Always use the brake before loading and unloading.
• Do not overload the machine.
• Keep the nameplate and all safety decals clean and readable.
• To avoid impairing the machine's stability, special precautions must be taken during operation of the unit, loading or unloading, with the fork arms in the
upper position:
- The machine must be moved slowly and smoothly.
- While moving, make sure that no part of the fork arms or of the load comes in contact with an obstacle.
- Before lowering the fork arms, make sure that no obstacle is below them.
- If it is necessary to move the machine on a small slope, the gradient must be no more than 2% and the machine must be unladen, with the fork arms facing
downgrade.
TECHNICAL DATA
Model
Maximum loading weight
Minimum loading height
Maximum lifting height
Dimensions of forks
Wheels
Protective screen
Weight
WORK AREA REQUIREMENTS
• The ambient temperature must be -25~+45°C.
• The floor must be even, smooth and hard.
• The gradient of the ground must be less than 2%.
• The ambient lighting must be at least 50 lux.
OPERATING INSTRUCTIONS
• Oil should be filtered clean and maintained at a sufficient level.
• Before operating the machine, make sure that every structure is normal and every joint part is tight.
• Loads must be placed on the fork arms uniformly.
• Make sure that heavy loads do not remain on the fork arms for an extended period of time after finishing work with the machine.
• When a load is lowered, the pedal should be trod lightly and slowly in order not to lower the load suddenly and cause unsafe situations.
OTHER GENERAL INFORMATION
• Use only qualified spare parts.
• When slinging the machine into a container or in a vehicle, a steel rope about 1.5 meters long is needed.
• Be sure of the tightness of the steel rope and that the lifting equipment used can lift the machine.
• The correct slinging position is shown in figure 1 (see next page).
2
BWR5516
1 ton
90 mm
1.6 m
1150 × 560 mm (for euro pallets)
Nylon (back wheels with brake)
Iron net
182 kg
WWW.NIKOLAOUTOOLS.COM
BWR5530
1 ton
90 mm
3 m
1150 × 560 mm (for euro pallets)
Nylon (back wheels with brake)
Iron net
298 kg