bbluv Uvi Mode D'emploi page 7

4. Press and hold the Power button
for 3 seconds. A fast blinking red light
means your Üvi is ready to begin
the sterilization process.
5. To start a cycle, press the Power button
again. The red light will blink more
slowly during the cycle, which lasts about 4
minutes.
NOTE:If using the product for the first time or if the product has not been in use for a long period of time, it
my take a few tries to turn on the internal UV lamp
6. When the sterilization cycle finishes, the UV lamp
automatically and the red light will stop flashing.
To stop the sterilization process once it has begun, press the Power
button again and wait for the UV lamp
B
for the fast blinking red light to resume. You can resume
the process by pressing the Power button
To turn your Üvi completely off during the sterilization process,
press and hold the Power button
CLEANING & MAINTENANCE
• Never use chemical cleaners, sprays, or liquid detergents.
• Clean your sterilizer regularly with a dry cotton cloth.
• Do not immerse the device in water. Avoid exposing the product
to water.
B
B
to shut off and
D
again.
B
for 3 seconds.
B
Üvi
EN
will switch off
D
7