Silver King SKMF34DW Manuel Technique page 2

TECHNICAL MANUAL
SILVER KING MOBILE FREEZER
MODELS SKMF34DW, SKMF34DWSL
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most reliable
equipment in the industry today. Please read this manual and the accompanying warranty information before operating your new
Silver King unit. Be sure to complete and mail the warranty card within 10 days of purchase to validate your warranty.
UNCRATE AND INSPECT FOR DAMAGE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following the instructions printed
on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a written
claim for any evidence of mishandling. Be sure to save all packaging materials if a claim is to be filed.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. The
covering can be readily stripped from the unit before installation. After removing the covering, wash the interior and exterior
surfaces using a warm, mild soapy water solution and a sponge or cloth, rinse with clean water and dry thoroughly.
Casters
The unit comes with the Casters installed. Check to make sure that the Casters are tightly fastened to the cabinet base to prevent
damage to the base.
Location
When locating the freezer, convenience and accessibility are important considerations, but the following factors must be observed:
• The unit must be level.
• Allow at least 6 inches of space at both ends to allow for proper air flow through the louvered panels. The space above the unit
should be open to allow access to the product.
• Avoid placing the freezer next to ovens, heating elements or hot air sources that would affect the performance of the unit.
Electrical Considerations
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to power. The
specifications on the data plate supersede any future discussion.
The standard freezer is equipped with an eight (8) foot power cord that requires a 115 Volt, 60 Cycle, 1 Phase properly grounded
electrical receptacle. The power cord comes with a 3 prong plug for grounding purposes. Any attempt to cut off the grounding
spike or to connect to an ungrounded adapter plug will void the warranty, terminate the manufactures responsibility and could result
in serious injury.
The circuit must be protected with a 15 or 20 amp fuse or breaker. The use of extension cords is not recommended with this unit.
1