Nakayama PRO SP1315 Mode D'emploi page 5

EN
Three Phase
Cable length / Cross-sectional area of conductor (mm)
Motor
To choose the required cutting area of cable according to the power of pump and length
of external cable to ensure the normal operation of motor.
Technical Data
SP1315
SP1115
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the
products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be
included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repairs, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The manufacturer and the importer
shall not be liable for injuries and damages resulting from the use of non-conforming equipment.
5
380-415V 50/60Hz
Voltage/Frequency:
Input power:
Max. head:
Max. flow:
Port diameter:
Additional features:
Voltage/Frequency:
Input power:
Max. head:
Max. flow:
Port diameter:
Additional features:
WWW.NIKOLAOUTOOLS.COM
Warning! Electrical connections can only be
performed by electrical professionals, and
please comply with state regulations.
Single phase with capacitor
connection demonstration
Three phase with six cable Y
connection demonstration
Connections for across-the-line
starting, running,and any reduced
voltage starting except WYE-
DELTA type starters.
230V/50Hz
1300W
12m
18000l/h
2"
Equipped with knife (cutting mechanism)
230V/50Hz
1100W
10m
15000l/h
2"
Equipped with knife (cutting mechanism)
Wiring figure