Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
Installation
1.
Lay the product evenly over the mattress, making sure it lies flat and without creases.
2. The product should be placed so that the plug and cables are at the top of the mattress,
where the pillows will lie. Make sure the control panel is easily accessible.
3. Tuck the elastic bands into the bottom corners of the mattress.
4. The product can be used as a fitted sheet or covered with a fitted sheet and blankets
provided the control panel and cables remain uncovered.
Operation
1.
Plug the control panel into the power connector of the product.
2. Insert the plug into the power outlet.
3. Slide the control panel switch up so that ON appears. The display turns on. To save energy,
the display turns off automatically after 10 seconds when the control panel is not in use. The
product will continue to heat at the selected settings.
4. By default, the temperature is set to setting 9 and the timer is set to setting 1. Press the
control panel buttons to set the temperature and timer to the desired settings (see "Setting
the temperature" and "Setting the timer").
5. Return the switch to OFF to turn the product off.
6. Unplug the product and wait for it to cool down before folding it.
Setting the temperature
The product is equipped with two separate heating elements that each heat a part of the
product: the upper body at the top of the product (where the plug is located) and the legs and
feet at the bottom. The two heating elements can be operated separately from each other.
1.
Press the "Body" button and/or "Feet" button to set the heating for each section. You
can choose between setting 1 (low) to 9 (high). When you turn on the control panel, the
temperature is automatically set to 9.
2. Adjust the heating setting as needed when you go to sleep. We recommend preheating
the product 10 to 15 minutes before going to bed with a setting between 6 and 9 and then
switching to a lower temperature between 1 and 3.
3. To turn off a heating element, press the button of the element ("Body" or "Feet") until "0"
appears.
Setting the timer
The product is equipped with a timer for automatic shutdown.
1.
Press the "Timer" button to set the heating time. The default time is 1 hour.
2. Select the desired time:
Settings 1 to 9 = 1 hour to 9 hours.
Setting H = 12 hours (maximum duration).
For continuous use (9 or 12 hours), we recommend choosing a lower temperature (heating
setting 1, 2 or 3).
20
Publicité
