Kobalt SGY-AIR132TZ Mode D'emploi page 10

ASSEMBLY INSTRUCTIONS
1. Remove the air inlet protective cap from the
air inlet (F) (See Figure 1).
2. NOTE Use threaded sealant tape (not included)
on the threading of the male plug. Once sealant
tape is properly in place, tighten male plug turning
clockwise with a wrench (not included) for air tight
connection. DO NOT OVERTIGHTEN.
3. Mount a male plug (not included) by hand
into the air inlet (F) (See Figure 2).
4. Place 2 - 3 drops of air tool oil (not included)
into the male plug before each use
(See Figure 3).
1
2
3
10