EFBE-SCHOTT TO 410 Mode D'emploi page 7

Fax +32 2 359 95 50
OPERATION
•
Before using your appliance for the first time, check if it is clean (see "Maintenance and
cleaning") as it comes into direct contact with bread. Check if any object has fallen into
the slot.
•
In the first time, connect the appliance only to a mains earthed wall socket. A grommet
on the bottom of the appliance enables to maintain the cord by positioning it to the
backside of the appliance.
•
Place the bread slices in the slot (for the French bread, cut a loaf shorter than the slot,
then cut it in two pieces along its length). Your appliance is provided to receive French
bread, but also pieces of toast or other bread slices if their thickness and their length are
shorter than the one of the slot.
•
Press down the bread carriage handle until it stops. In the meantime, the grid inside the
slot will tighten around the bread to keep it in the centre of the toaster. Then release the
pressure and the handle will stay in the lower position, which means that the heating
process has begun. If the handle comes up immediately, check if the appliance is
plugged in as it blocks only when the unit is plugged in.
•
You can adjust the browning intensity to obtain a more or less toasted bread by
positioning the browning control selector to one of the degrees marked from 1 to 6.
Therefore you only have to turn clockwise to increase the intensity, and anticlockwise to
decrease it. The higher the number is, the more toasted the bread will be.
•
During the functioning, if you think that the bread is toasted enough or for another reason,
you can break the heating process, simply by pressing the cancel button (
•
The reheat button (
which is not toasted enough during a short time without modifying the browning degree.
•
The defrost button (
•
At the end of the cycle, the bread carriage handle unlocks and you can take the toast
out. Your toaster has an extra lift function, i.e. you can lift the bread carriage handle even
a little more when it has unlocked in order to facilitate the withdrawal of the toast that is
ready.
•
Always unplug the appliance after use and let it cool down before handling or storing it.
•
When storing your appliance, wind the cord around the cord storage facility underneath
the appliance and attach the end of the cord in the notch.
RACK FOR BUN WARMING
Your appliance is provided with a bun warmer. To warm the buns just place the support on the
top of the toaster.
MAINTENANCE AND CLEANING
•
Before attempting any cleaning operation, make sure the toaster is unplugged from the
supply socket and fully cooled down.
•
To remove bread crumbs, slide the crumb tray situated on the side of the appliance. To
open it, slide it horizontally. To close it, proceed inversely.
•
To clean the exterior surfaces, simply wipe over with a soft damp cloth. On no account
must the toaster be immersed in water.
•
NEVER IMMERSE THE TOASTER IN WATER OR ANY OTHER LIQUID.
•
All other maintenance and repair should be performed by a qualified technician. No
guarantee claims will be accepted if the appliance has been opened inappropriately.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
) allows you to reheat already toasted bread or to toast bread
) allows you to toast bread that has been frozen beforehand.
7
Assembly page 7/7
).
SC TO 410 - 081208