Publicité
Les langues disponibles
Les langues disponibles
You have just acquired an AXS2 uninterruptible power unit by SLAT, and we thank you for your choice.
In this manual, you will find all the instructions you need to install it.
For proper functioning of the unit, we recommend that these instructions be followed very carefully.
AXS2 is an emergency power supply designed to be connected to the public distribution 230V network. It
ensures continuity of service for equipment in case of power failure. You can find more information in the
datasheet for download on our website www.slat.com
•
To avoid any risk of electric shock, all INTERVENTIONS must be carried out with the equipment
SWITCHED OFF (upstream two-pole circuit-breaker open).
•
Interventions with the equipment switched on are authorized only when it is impossible to switch the
equipment off. The operation must only be performed by qualified personnel.
•
During installation, connect the ground wire first and disconnect it last when dismantling.
•
Mount the appliance in a vertical position.
•
Provide sufficient convection (top / bottom clearance minimum 30mm)
Size and protect cables defined according to the maximum current input / output (≥0.3mm²/A).
•
•
Observe the thermal and mechanical limits.
•
The batteries to be connected are sealed lead acid type.
•
The battery is maintenance-free. Do not open it.
•
Attention, there is a blast hazard if the battery is replaced with a wrong battery type!
•
Scrap the used batteries according to the directives
•
Indoor use only.
•
This equipment is not suitable for use in locations where children are likely to be.
•
Clean the cabinet with a soft rag.
Environment and public health protection standards and directives
Complies with:
-
EN IEC 62368-1 (2020) + A11 (2020)
-
EN IEC 61000-6-1 (2019)
-
EN IEC 61000-6-2 (2019)
-
EN IEC 61000-6-3 (2021)
-
EN IEC 61000-6-4 (2019)
-
55022 (2006) +A1 (2007) class B
At the end of life, the product must be recycled. SLAT recycles its products at end of life.
Conformity of the product with the requirements of the European directives.
Disposal of the product in an appropriate collection and recycling structure.
This product should not be disposed of with household waste.
Compliance with the European Directive restricting the use of certain hazardous substances in
electrical and electronic equipment.
Protective earth terminal
Caution, risk of electric shock
Code :
ENGLISH - INSTALLATION MANUAL
Safety precautions
Definition of the symbols
180150004Da
- NDU :
NOT150002Da
-
Edition : 09/24
3
Publicité
