Publicité
Les langues disponibles
Les langues disponibles
Stagnoli
Attention!
•
This manual is for qualified technical personnel only for installation purposes and not
intended for the end user; it's the installer's job to explain to the user how the
automatism works, about possible hazards related to it and about the need for
periodical maintenance.
•
The automatism must be installed by qualified personnel only, observing current
standards concerning automatic closing systems. More specifically, installation
conformity calls for observance of directive 89/392 and standards EN 12453 and EN
12445.
•
As ALPHEO is made specifically to control swing gates it is forbidden to use the
product for different purposes or improperly.
•
Use original components only. Stagnoli is not liable for damages if other components
are used.
•
Make certain that the gate structure is solid and suitable for being motor-driven.
•
When the gate is moving make sure there are no points of friction and there is no
chance of it derailing.
•
Make absolutely certain the power is disconnected before carrying out any work on
the device.
•
Connect the power lead to supply lines with adequate electrical protection only;
install a device to guarantee disconnection of all the phases from the mains that has
a distance of at least 3.5 mm between the contacts.
•
Pay particular attention when deciding which safety devices to install and their
location. Always install an emergency stop device that will cut power off in the case
of necessity.
•
Only qualified personnel must be allowed to service the unit and access the internal
parts of the geared motor.
•
Irreversibility of the geared motors means an electric lock does not have to be
installed and, in the case of black-out the release device (protected by a
personalised key) lets you open the gate by hand. We do however recommend
using an electric lock to ensure correct closing especially if the swing gates are
longer than 2.5 metres.
Istruzioni Instruction Instructions Betriebsanleitung
18
Publicité
