Publicité
CONTROLS / OPTIONS:
1) (STANDARD) 0-10V DIMMING
a. See WIRING section (page 4) for connection details
b. For use with low voltage 0-10V controls (wall dimmers, remote occupancy sensors, or other devices) – not supplied.
2) (OPTION) ALO SWW (ADJUSTABLE LUMEN, SWITCHABLE WHITE)
a. Two switches located on the side of the Main Driver Enclosure allow for adjustment of the light output and the color of light
(CCT) produced. See Figure 11 and 12.
b. The switch on the left can be used to set lumens to low (left position), medium (center), or high (right position).
c.
Similarly, the switch on the right can be used to set the CCT to 3500K (left position), 4000K (center), or 5000K (right position).
d. Once installed, the switches will not be accessible to adjust without access above the ceiling. Please confirm the switches are in
the desired position before completing installation. Fixture ships set to highest lumens and 4000K color.
NOTE: If using 0-10V low voltage dimming with ALO SWW fixtures, connect fixtures to low voltage dimming controls per WIRING section (page 4).
Please make sure that all the Adjustable Lumen Output switches are set to their highest setting. If the ALO switch of any fixture is set in the medium
or low position, then all fixtures that are on that control circuit will be limited in their maximum output to the lowest switch setting.
NOTE FOR USE WITH BACKUP POWER: Any non-powered ALO SWW fixture connected to a group by 0-10V controls will create a load on the
dimming circuit and will dim all attached fixtures. If using fixtures with a backup power device (like a generator) where only a few of the fixtures in a
group will be powered when normal power is lost, then a means of disconnecting the backup powered fixtures from the 0-10V circuit will be required
to insure they will operate at full output (still limited by Adjustable Lumen Output switch setting).
FIG. 11: STAKS 1x4 AND 2x4 ALO SWW SELECTION SWITCH
FIG. 12: STAKS 2x2 ALO SWW SELECTION SWITCH
SAVE THESE INSTRUCTIONS / CONSERVEZ CES INSTRUCTIONS / GUARDE ESTAS INSTRUCCIONES
www.lithonia.com I 800-705-SERV (7378) I
We reserve the right to change design, materials and finish in any way that will not alter installed appearance or reduce function and performance.
Contractor Resources
Check out helpful programs, tools, installation videos and more!
Ressources de l'entrepreneur
Découvrez des programmes utiles, des outils, des vidéos d'installation et plus encore !
Recursos del Contratista
¡Vea programas útiles, herramientas, videos de instalación y más!
TechSupport-CommercialIndoor@AcuityBrands.com
STAKS LED INSTALLATION INSTRUCTIONS
I © 2023 Acuity Brands Lighting, Inc. All Rights Reserved.
6 of 7
Publicité
