Publicité
WIRING:
1. Using a screwdriver (not supplied), remove access plate as shown in Figures 3 & 4, with grid power OFF make electrical
connections from supply and properly ground as local codes dictate. See Figure 5.
a. GREEN wire – Ground
b. WHITE wire – Neutral line in
c. BLACK wire – Hot line in
2. If the dimming leads (purple & pink) aren't being used, cap them off (if not already done).
Dimming leads are for low voltage dimming only.
a. PURPLE wire – 0-10V (+) (can be capped off if not in use)
b. PINK wire – 0-10V (-) (can be capped off if not in use)
3. Reinstall access plate with screwdriver.
4. (OPTION) Set the adjustable lumen and selectable white switches (ALO SWW) to desired setting (SEE CONTROLS SECTION)
WIRING, CONTINUED
5. (BATTERY WITH ALO SWW OPTION) If fixture includes factory installed emergency battery and ALO SWW control option.
See Figure 6.
a. GREEN wire – Ground
b. WHITE wire – Shared Neutral line in
c. BLACK wire – Switched Hot line in
d. Labeled BLACK wire – Unswitched Hot line
in to charge emergency battery
e. TEST SWITCH – Can be mounted in
adjacent ceiling tile with included face
plate and junction box (not included)
FIG 6: FACTORY BATTERY
WIRING DIAGRAM
WITH ALO SWW
Note: The emergency battery will only
energize the higher color LEDs when in
emergency mode (normal power removed).
It will not be possible to control the dimming
or color when in emergency mode.
www.lithonia.com I 800-705-SERV (7378) I
We reserve the right to change design, materials and finish in any way that will not alter installed appearance or reduce function and performance.
TO DIMMING
CONTROL
DEVICE
:
TechSupport-CommercialIndoor@AcuityBrands.com
STAKS LED INSTALLATION INSTRUCTIONS
WIRE CONNECTORS (NOT SUPPLIED)
TO LED LIGHT ENGINE
FIG 5: WIRING DIAGRAM
I © 2023 Acuity Brands Lighting, Inc. All Rights Reserved.
TO LED LIGHT ENGINE
PURPLE
PINK
4 of 7
Publicité
