Mc Haus Artic 100 Mode D'emploi page 101

TROUBLESHOOTING
The following cases may not always be a malfunction.
Please check the suggestions below before requesting service.
It does not work
1. If the protector trips or the fuse is blown.
2. Please wait for 3 minutes and restart; the protective device may be preventing the unit from operating.
3. If the batteries in the remote control are exhausted.
4. If the plug is not properly connected.
Runs for a short time
1. If the set temperature is close to the room temperature, you can reduce the set temperature.
2. The air outlet is blocked by an obstacle. Remove the obstacle.
It works but does not cool
1. If the door or the window is open.
2. If there is another appliance operating with heat, such as a heater or a lamp etc...
3. The air filter is dirty, please clean it.
4. The air outlet or air inlet is blocked.
5. The set temperature is too high.
Water leakage during movement.
1. Drain condensate before moving.
2. To avoid water leakage, place the unit on level ground.
Does not work and water is full (indicator E4)
1. Remove the rubber stopper to drain the water.
2. If you often find yourself in this condition, contact a qualified technician.
101