Würth HDR-HW 180-14 Instructions D'utilisation Originales page 18

CLASSIFICATION OF RISKS:
! Danger
Identifies an imminent risk which could lead to serious or fatal
injury.
!
Warning
Identifies a risk situation which could lead to serious injury.
Information
Identifies a risk situation which could lead to minor injury or
damage to things.
! Warning
You must read this manual before installing, starting up and
using the high pressure washer.
This manual is an integral part of the product.
Read the warnings and instructions contained in the manual
carefully as they provide important information on USER SA-
FETY and MAINTENANCE, paying particular attention to the
general safety regulations.
KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE
REFERENCE.
!
Warning
Those operating and servicing the high pressure washer must
be aware of the contents of this manual.
CLASSIFICATION
The user must observe the conditions of use of the applian-
ce prescribed by the Rules, and particularly he must respect
the following classification:
As for the protection against electric shock, the H.P.cleaner
belongs to CLASS I.
The H.P. cleaner is factory set and all its safety devices are
sealed. It is forbidden to alter their adjustment values.
In the Hot water cleaner the water is heated by a burner feed
with Diesel fuel.
The H.P. cleaner must be always used on a firm and flat
ground, furthermore it must not be moved while it is working or
connected to the electric supply.
Failure to observe this prescription may cause danger for the
user.
The H.P. cleaner must not be used in the presence of corrosive
or potentially explosive atmospheres. (vapours or gas)
PREFACE
English
GENERAL SAFETY RULES FOR
THE USE OF HIGH PRESSURE
Warning
!
- The electric connection must be performed
by qualified technicians who are able to
work in observance of the governing rules
(in compliance with the provisions of the IEC
60364-1 standard) and of the manufacturer's
instructions.
A wrong electric connection may cause
damage to persons, animals or things, and
the manufacturer
responsible for these.
- The H.P. cleaners with power lower than 3
kW are equipped with a plug for connection
to the electric supply.
In this case please check if the electric
power system and the electric sockets are
compatible with the max. power of the ap-
pliance indicated on the plate. (kW). In case
of doubt, please apply to qualified personnel.
If the socket and the plug of the machine are
not compatible, have the plug replaced with
a suitable type by qualified personnel.
- Before connecting the machine make sure
that the data indicated on the plate corre-
spond to those of the electric supply.
- Do not use extensions to power the high
pressure washer.
If you use an extension, the plug and socket
must be watertight. Unsuitable extensions
may be dangerous.
- The electric safety of this machine may be
assured only when it is properly connected to
an efficient grounding system in accordance
with the governing laws for electric safety. (In
compliance with the provisions of the IEC
60364-1 standard)
- 18 -
CLEANERS
cannot be considered