Satco NUVO S11878 Manuel D'installation

LED CCT DIRECTIONAL LOW PROFILE
DOWNLIGHTS, FLAT LENS, REMOTE DRIVER
Models: S11878, S11879
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• Disconnect power before installation or any maintenance
of the fixture.
• To avoid damage, falling, electric shock or fire, do not modify the fixture
or replace accessories without confirming with the supplier first.
• Only authorized, qualified personnel should install this fixture and should
follow the owner's manual.
• Do not dismantle the fixture without the supplier's authorization.
• Do not touch the power supply when the fixture is operating.
• For use in environments where an accumulation of non-conductive dust
on the fixture may be expected.
• Suitable for indoor/outdoor installations.
• For use with minimum 90°C supply conductors.
IMPORTANT: Consult a qualified electrician to ensure correct branch circuit
conductor is used. This product must be installed in accordance with the
applicable installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Model Decription
S11878 4" Round
S11879 6" Round
INSTALLATION
TOOLS REQUIRED: Hole saw, measuring tape and connector cables
(as needed).
NOTE: Use extensions if necessary. Available connector cables are
6' (1.8m). Connector cables are linkable.
1. Turn power OFF from the electrical panel before starting installation.
2. Cut a hole in the ceiling for the downlight in a suitable position. Refer to
Hole Cut Dimensions chart (below).
3. Run the electrical wire from the switch (power supply wire) through the
mounting hole. Use NMD90 Romex or BX cable. See Figure A.
4. Open the Junction Box swing cover and remove the appropriate knockouts.
5. Insert the power supply wire through the knockout and fasten with a cable
connector (not included).
6. Connect wires inside the Junction Box using the quick connect terminals.
Connect green ground with the green box wire. Connect the black and white
power leads with the matching black and white box wires. See Wiring Diagram.
7. Put all wires and connections back into the box and close the cover securely.
8. New Construction Applications: Junction Box shall be firmly secured
to the studs, joists or similar fixed structural units.
Remodel Applications: Do not require the Junction Box to be firmly secured
to fixed structural units.
9. Choose desired color temperature. See Figure B.
10. Bend back the two torsion springs and slowly fit the fixture through the ceiling
hole. The torsion springs will pull the fixture into place. See Figure C.
11. Once installation is complete,
turn power ON to confirm the
fixture is working properly.
Hole Cut Dimensions:
4" Round: ø110mm (4-3/8")
6" Round: ø160mm (6-1/4")
© Copyright 2023 Satco Products, Inc. 7/23 v1.3
Watts Volts CCT
11W
120V 27K,30K,35K,40K,50K
14W
WIRING DIAGRAM
Black
wires
White wires
Green wires
Quick connect
terminals
Fixture Includes:
1 LED Lamp
1 Junction Box
CRI Finish
90 White
Figure A
Figure B
Figure C
Cable to fixture
Power supply
Features:
4" or 6" Gimbal
with frosted lens
Satco Products, Inc.
Brentwood, NY 11717