EN
Add 3 minutes to the preparation time when the appliance is cold.
Note: If you want, you can also let the appliance preheat without any ingredients inside. In that case,
turn the timer knob to more than 3 minutes and wait until the heating-up light goes out ( after approx. 3
minutes). Then fill the basket and turn the timer knob to the required preparation time.
a The power-on light and the heating-up light go on.
b The timer starts counting down the set preparation time.
c During the hot air frying process, the heating-up light comes on and goes out from time to time. This
indicates that the heating element is switched on and off to maintain the set temperature.
d Excess oil from the ingredients is collected on the bottom of the pan.
8. Some ingredients require shaking halfway through the preparation time (see section 'Settings' in this
chapter). To shake the ingredients, pull the pan out of the appliance by the handle and shake it. Then slide
the pan back into the airfryer and continue to cook (fig.7, fig.8 & fig.9).
Caution: Do not press the button of the handle during shaking.
Tip: To reduce the weight, you can remove the basket from the pan and shake the basket only. To do so, pull
the pan out of the appliance, place it on a heat-resistant surface and press the button of the handle.
Tip: If you set the timer to half the preparation time, you hear the timer bell when you have to shake the
ingredients. However, this means that you have to set the timer again to the remaining preparation time
after shaking.
Tip: If you set the timer to full preparation time, there is no timer bell during cooking before finishing, you
can pull out the pan at any time to check the ingredients cooking condition, the power will shut down
automatically and resume after slide the pan back into the appliance(timer still on).
9. When you hear the timer bell, the set preparation time has elapsed. Pull the pan out of the appliance and
place it on a heat-resistant surface (fig.10).
Note: You can also switch off the appliance manually. To do this, press the temperature control button
to 0, or pull out the pan directly.
10. Check if the ingredients are ready.
If the ingredients are not ready yet, simply slide the pan back into the appliance and set the timer to a few
extra minutes.