Ultra Max 8B-UM1833-208V Instructions D'installation Et D'utilisation page 8

Please take time to read the following safety operating instructions. They are
the key to the successful operation of your Ultra-Max Conveyor Oven.
SAFETY TIPS
For your safety, read before operating.
If you smell gas:
1. DO NOT try to light any appliance.
2. DO NOT touch any electrical switches.
3. Use an exterior phone to call your gas
supplier immediately.
4. If you cannot reach your gas supplier, call
the fi re department.
In the event of a power failure:
1. Turn all switches off.
2. DO NOT attempt to operate the oven until
the power is restored.
To Start:
Push power switch "ON".
If burner does not lght in one minute push the power
switch to the"OFF" position and wait five minutes.
After five minutes, retry.
Adjusting TIME and TEMPERATURE:
1) Press the up and down buttons (
hold for four seconds until TIME display goes blank.
2) Press the enter button ( ) to switch between TIME
and TEMPERATURE.
3) Press the up button ( ) to increase or the down button (
decrease TIME or TEMPERATURE. Hold button down for
faster display changes.
4) After five seconds, the new numbers will be saved and the oven
will display new settings.
"HEAT" LIGHT
ON
OFF
) at the same time,
) to
®
8
General Safety Tips:
1. If the oven needs to be moved for any
reason, the power must be disconnected
from the unit before doing so.
2. DO NOT remove the control box cover
unless the oven is unplugged.
OPERATION
To turn the oven on:
1. Push the power switch to "ON."
2. After the fan begins to build pressure,
the pressure switch will provide power to
the control board to engage the heating
element contactor. You should hear an
initial "click" from the contactor as it begins
to heat.
To adjust the time and temperature:
1. Press the DOWN and UP arrows
( ) at the same time. Hold for four
seconds until the TIME display goes
blank.
2. Press the ENTER button (
between TIME and TEMPERATURE.
3. Press the UP arrow (
DOWN arrow ( ) to decrease the TIME
or TEMPERATURE. Hold either button
down for faster display changes.
4. After fi ve seconds, the new numbers will
be saved and the oven will display the new
settings.
To turn the oven off:
1. Push the power switch to "OFF." The
oven is equipped with a cool-down feature
for motor shaft and bearing protection.
This enables the blower motor(s) to run
regardless of the controller status. The
blower(s) continue to run until the oven
cools to a safe temperature.
) to switch
) to increase or the