RS Pro RSDG800 Serie Démarrage Rapide page 3

General Safety Summary
Carefully read the following safety precautions to avoid personal injury and prevent
damage to the instrument and any products connected to it. To avoid potential
hazards, please use the instrument as specified.
Only qualified technician should perform service procedures
To Avoid Fire or Personal Injury
Use Proper Power Line
Use only the special power line of the instrument which is approved by local state.
Ground the Instrument
The instrument grounds through the protective terra conductor of the power line. To
avoid electric shock, the ground conductor must be connected to the earth. Make
sure the instrument is grounded correctly before connecting its input or output
terminals.
Connect the Signal Wire Correctly
The potential of the signal wire is equal to the earth, so do not connect the signal
wire to a high voltage. Do not touch the exposed contacts or components.
Look Over All Terminals' Ratings
To avoid fire or electric shock, please look over all ratings and sign instruction of the
instrument. Before connecting the instrument, please read the manual carefully to
gain more information about the ratings.
Do Not Operate with Suspected Failures
If you suspect the product is damaged, please let a qualified service personnel check
it.
Avoid Circuit or Wire Exposed Components
Do not touch exposed contacts or components when the power is on.
Do not operate in wet/damp conditions.
Do not operate in an explosive atmosphere.
Keep the surface of the instrument clean and dry.
3