Philips Lumea BRI951 Mode D'emploi page 19

Learning more about your Lumea
Charging
Charging the device
Attachments
Fully charge the battery before you use the device for the first time and when it
is empty. Charging the battery takes up to 1 hour and 40 minutes. Charge the
device when the charging light lights up orange during use to indicate that the
battery is low and will run out soon.
Fully charged battery provides at least 130 flashes at light intensity setting 5.
1 Turn off the device.
2 Insert the small plug into the device and the adapter into the power outlet.
-
During charging, the charging light flashes white.
-
When the battery is fully charged, the charging light lights up white
continuously.
-
Never cover the adapter and device during charging.
Note: The adapter and device can feel warm during charging. This is normal.
Note: This device is equipped with battery-overheat protection and does not
charge if the room temperature exceeds 40 °C.
3 After charging, remove the adapter from the power outlet and pull the small
plug out of the device.
Tip: Charge the device after each use to save battery life.
Note: The battery capacity is not enough for a full body treatment. We advise
you to use the device corded while treating large body areas such as legs.
For optimal results, it is important to use the correct attachment intended for
the specific body area you want to treat. Lumea offers full‑body treatment with
several attachments designed for use on specific body areas. SenseIQ
technology adapts the treatment program when a different attachment is
connected.
Note: The device may not work anymore and show an error when there is dirt
on the attachment connector. Clean the contact leads when this occurs.
To place the attachment, simply snap it onto the light exit window.
English
19