SUPERIORE HN361BSS Manuel D'utilisation Et D'entretien page 13

4. CLEANING THE INSIDE OF THE APPLIANCE
The electrical parts or parts of the blower assembly inside the range hood must not be cleaned using
liquids or solvents.
HOOD INSTALLATION
WARNING: Failure to install the screws or fixing device in accordance with these instructions may result in elec-
trical hazards.
In the table of figure 4 you can identify the measures referring your model.
Take measurements from the hob (Pic. 2), mark with a pencil on the wall where to drill the points (Pic. 6).
Drill, insert the screw anchors ø 5/16 and partially tighten the screws (Pic. 6 B,A,C).
Hook the hood to the screws, tighten the screws after checking if the hood is in the bubble.
To prevent the dropping of the hood due to pressure from below, fasten it to the wall with screws (Pic. 5).
Install the chimney under the hob, adjut and fix it on the bracket following the picture 7.
13