Publicité
Les langues disponibles
Les langues disponibles
Cancell ing or modifying a wash cycle setting. . .
A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have
already been released, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser
must be refilled (see the paragraph entitled " Loading the Detergent " ).
Press the ON/OFF button, and the ON light will turn off. Rotate the dial in the clockwise direction to the desired cycle setting (see
the section entitled " Starting a wash cycle. . . " ). Then, turn the dishwasher back on using the ON/OFF button.
At the End of the Wash Cycle
STOP
STOP
STOP
Forget to Add a Dish?
A forgotten dish can be added any time before the detergent cup opens.
1
Pull the door handle.
2
Do not open the door until the water spray action stops. Steam may rise out of the dishwasher.
3
Add forgotten dishes.
4
Push the door to close . When the door is properly closed, a click will sound.
FILTERING SYSTEM
For your convenience, we have placed the drain pump and filtering system within easy reach inside the tub. There are three
components of the filtering system: the main filter, the coarse filter, and the fine filter.
2
1
3
CARING FOR THE DISHWASHER
T o clean the control panel use a lightly dampened cloth then dry thoroughly. To clean the exterior use a good
appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
When the dial stops turning and is aligned with the STOP mark(see figure), the cycle has finished .
Turn off the appliance using the ON/OFF button, shut off the water supply and open the door of
the dishwasher. Wait a few minutes before unloading the dish washer to avoid handling the
dishes and utensils while they are still hot and more susceptible to breakage.
1
Main filter
Food and soil particles trapped by this filter are pulverized by a special jet on the lower
spray arm and washed down the drain.
2
Coarse filter
Larger items, such as pieces of bone or glass, that could clog the drain are trapped in the
coarse filter. To remove an item caught in this filter, gently squeeze the tabs on top of this
filter and lift it out.
3
Fine filter
This filter holds soil and food residue in the sump area and prevents it from being
redeposited on the dishes during a cycle.
Protect Against Freezing
If your dishwasher is left in an unheated place during the winter, ask a service technician to:
1
Cut off electrical power to the dishwasher
and remove fuses or trip circuit breaker.
2
Turn off the water supply and disconnect the
water inlet pipe from the water valve.
3
Drain the water from the inlet
(Use a pan to catch the water.)
4
Reconnect the water inlet
water valve.
5
Remove the plastic sump cover in the
tub the bottom and use a sponge to
soak up the water in rubber boot.
pipe
and water valve.
pipe
to the
8
Publicité
