Télécharger Imprimer la page

Ryobi RY18STPA Mode D'emploi page 4

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
Make sure that the filter is secure and, the
water barrel hook is fixed if to be used.
Ensure that all connections are leak free.
Use a thread seal tape or a suitable sealant
on the connection thread.
When tightening threaded connections,
please do not apply excessive force that
may cause damage.
Do not use the product for corrosive,
abrasive, explosive or dangerous liquids.
Fluids other than water damage the product,
can create a fire hazard, and could cause
physical injuries to the operator.
Do not use the product with potable water.
Do not operate the product without liquid.
Do not run the product dry.
Do not use the product when people are in
the water.
Do not remove the hose while the product is
still operating.
Pollution of the liquid could occur due to
leakage of lubricants.
Water discharged from the product may
cause the ground to become wet and may
cause slipping. Make sure to clean the
discharged water after operating the product.
Do not discharge water to areas with electrical
or high voltage elements, active chemicals,
or other objects or substances that might
cause danger when mixed with water.
Hold the product securely where there is an
overmould grip. Always wear the wrist lanyard
except when the barrel hook is used. Do not
leave the product unsupervised while in use.
Make sure the product cannot tip over.
Do not expose the inside of the battery
compartment to rain or wet conditions.
The product is only water resistant when
the battery compartment is closed, locked,
and without damages. Water entering the
product increases the risk of electric shock.
ADDITIONAL BATTERY SAFETY WARNINGS
To reduce the risk of fi re, personal injury, and
product damage due to a short circuit, never
immerse the product, battery pack, or charger in
fl uid or allow fl uid to fl ow inside them. Corrosive
or conductive fl uids, such as seawater, certain
industrial chemicals, and bleach or bleach-
containing products, etc., can cause a short circuit.
4
Original Instructions
TRANSPORTATION AND STORAGE
Turn off the product, remove the battery
pack, and allow both to cool down before
storing or transporting.
Clean the product thoroughly before storing.
Remove any excess water by fully extending
the product. Store the product upright and fully
extended to drain water completely. Store the
product in a dry, well-ventilated area that is
inaccessible to children. Keep the product
away from corrosive agents, such as garden
chemicals and de-icing salts. Do not leave the
product outside during freezing conditions.
When transporting the product in a vehicle,
secure it against movement or falling to prevent
injury to persons or damage to the product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local
and national provisions and regulations.
Follow all special requirements on packaging
and labelling when transporting batteries
by a third party. Ensure that no batteries
can come in contact with other batteries or
conductive materials while in transport by
protecting exposed connectors with insulating,
nonconductive caps or tape. Do not transport
batteries that are cracked or leaking. Check
with the forwarding company for further advice.
MAINTENANCE
Use
only
original
replacement
parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
Servicing
requires
knowledge and should be performed only by a
qualified service technician. Have the product
serviced by an authorised service centre only.
You may make adjustments and repairs
described in this manual. For other repairs,
contact an authorised service centre.
Periodically inspect the pump, hoses, and
water inlet and filters. Ensure that the hoses,
water inlet, and filters are free from mud, sand,
and debris. Ensure there are no damages.
After each use, clean the product with a soft,
dry cloth. Keep the product dry, clean, and free
from oil and grease when not in use. Any part
that is damaged should be properly repaired or
replaced by an authorised service centre.
manufacturer's
accessories,
and
extreme
care
and

Publicité

loading