Fiilex Q500 Guide De Démarrage Rapide page 5

Basic Operation
Turning The Light On
•
Insert the PowerCon cable into the PowerCon Connection Port (19) and rotate
clockwise to lock in place. Plug the light in to an appropriate outlet. The On/Off
Button (20) will light red to signify it is in stand-by mode. Press the On/Off Button
(20) to turn on the light. The On/Off Button (20) will light green to signify it is in
working mode.
• Positioning The Q500
To adjust the Q500, grasp the Handles (11) then loosen the Tilt Lock Lever (10).
Adjust the angle to the desired position then tighten the Tilt Lock Lever (10) to
secure.
• Adjusting Beam Angle
Adjust the beam angle by turning the Focusing Knob (6). The lens tube will extrude
back and forth from the lamphead housing.
• Mounting The Q500
The Q500 can be mounted in a standing or hanging position with the Junior Pin
Receiver (7). In order to mount the light, insert the stud of the C-Stand into the Pin
Receiver (7) and secure by tightening the Stand Locking Pin (8). When mounting in
a hanging position, secure the light with a Safety Cable (Not Included).
• DMX Interface
The Q500 is equipped with two DMX interfaces. RJ45 (23) or XLR ports (21 & 17)
are used to send the DMX signal to the lamphead. Both interfaces include in/out
ports for the purpose of daisy-chaining the DMX line through to the next lamphead.
• USB Interface
The Q500 is equipped with a mini USB port for updating the Q500's firmware.
Please register your product at www.fiilex.com to be informed when firmware
updates are available.
3