Samsung SC05M21 Serie Mode D'emploi page 18

Troubleshooting
Symptom
Motor does not start.
Suction force is gradually
decreasing.
Cord does not rewind
fully.
Body overheating
Static electricity
discharge.
During using, stop the
unit.
Noise from the vacuum
cleaner increases and the
suction power is weak.
• This Vacuum cleaner is approved the following.
– Electromagnetic Compatibility Directive : 2004/108/EEC
– Low Voltage Directive : 2006/95/EC
18 English
• Check the cable, the power plug and outlet.
• Check if there is any blockage, and remove it if required.
• Please check the filters, and if required, clean as illustrated
in this manual.
– If filters are out of condition, replace them with new
ones.
• Pull the power cord out 2 - 3 m and press the Cord rewind
button.
• Check the filters, and clean as illustrated in this manual if
required.
• Reduce suction.
• This may also occur when air in the room is very dry.
Ventilate the room so that air humidity becomes normal.
• This vacuum cleaner has a special thermostat that protects
the motor in case of its overheating. If the vacuum cleaner
suddenly shuts off, turn off the switch and unplug the
vacuum cleaner. Check the vacuum cleaner for possible
source of overheating such as a full dustbin, a blocked
hose, pipe, or clogged filter. If these conditions are found,
fix them and wait at least 30 minutes before attempting to
use the vacuum cleaner.
• Disassemble the anti-tangle turbine inside the dustbin and
remove dust in it.
• After cleaning the anti-tangle turbine, reassemble it
correctly in the dustbin.
Checklist