Wrangler 2016 AB Instructions D'origine page 14

PROBLEM CAUSE
No solution Clogged filter.
flow. Low battery charge.
The solution valve is closed.
Obstruction in the solution hose.
Solution valve or linkage damaged.
Solution hose kinked.
Solution tank is empty.
Solution The solution valve is open.
flow does
Solution valve or linkage damage.
not stop.
Solution valve is dirty.
Damaged seat and washer in valve.
The valve stem is dirty.
Hose disconnected or damaged between solution tank and
valve.
Will not pick Squeegee is up. Squeegee hose is off
up any
Vacuum motor switch is "off".
water from
Recovery tank is full.
floor.
Vacuum shut-off float is stuck.
Obstruction/damage in the squeegee, squeegee hose or
standpipe.
Leaking over gasket.
Vacuum motor is not running.
Recovery drain hose not plugged properly.
Will not pick Debris on squeegee blades.
up all of the
Squeegee blade is worn/damaged.
water from
Obstruction/damage in the squeegee, squeegee hose, or
the floor.
standpipe.
Squeegee angle needs adjustment.
Vacuum motor worn out.
Recovery tank drain hose damaged.
Runtime is Electrolyte level is too low.
less than
when new
Tops of batteries are dirty / wet.
Battery terminals are dirty / damaged.
Batteries are sulfated. Caused by not recharging fully, or by
letting batteries sit discharged.
Batteries are not fully charged.
Battery(s) defective or worn out.
Damaged Charger
Cleaning is Brush / pad is worn.
not even.
Damage to brush assembly, casters or solution valve.
Machine Circuit breaker tripped.
does not
Loose battery connection
run.
Check fuse at rear of machine.
Batteries depleted
Battery charger was unplugged before the charge cycle was
completed.
NOTE: If any problems remain after taking the above steps, contact your local authorized distributor / service station for further
evaluation and repair
TROUBLE SHOOTING
SOLUTION
Clean filter.
Charge the batteries.
Open the solution valve.
Remove the obstruction.
Repair/replace the valve linkage.
Check for kinks at valve.
Fill the tank.
Close the solution valve.
Repair/replace the valve linkage.
Clean the solution valve.
Replace valve.
Clean and lubricate valve stem.
Reinstall or replace hose.
Lower squeegee. Reinstall hose.
Turn vacuum motor switch "on".
Empty tank.
Open float valve/remove obstruction.
Remove obstruction/repair damage.
Remove old gasket/replace.
Have an authorized serviceman repair.
Install drain hose plug properly.
Clean squeegee.
Reverse/replace squeegee blade.
Remove obstruction/repair damage.
Adjust angle.
Repair / replace vacuum motor.
Repair / replace recovery drain hose.
Add distilled water to cover plates and charge. Fill to
correct level after charging.
Clean / dry, and clean terminals.
Clean terminals and connectors. Replace damaged
cables. Check water & Charge.
Batteries may recover if equalized two, or three, times
in a row. Otherwise, replace bats.
Charge batteries until charger indicates full charge
cycle is complete.
Check for fault codes on the battery charger while the
batteries are charging. Have an authorized serviceman
test the batteries (specific gravity/charged volts/load
test).
Have an authorized serviceman repair.
Replace brush / pads.
Have an authorized serviceman repair.
Reset circuit breaker.
Tighten battery connection.
Replace if blown.
Wait (up to five minutes) and try again.