Publicité
Les langues disponibles
Les langues disponibles
Installing the handle
• Install handle to the door frame of the appliance.
• The handle is delivered in a separated package with screws together inside
the carton.
① Reveal two small holes on the door frame from inner side by pulling out a bit the
door seal.
② Aim the handle to the holes and insert the screws from inside.
③ Screw them up with screwdriver.
④ Put back door seal to cover the screws
Bracket installation
The appliance is equipped with a pair of brackets at the
top(②) and at the bottom.
This pair of brackets might not be needed and can be
removed as per your actual installation situation when you
build the appliance into your closet.
If the opening size of your closet is bigger than the
appliance, you could fix 4 screws(①,ST4.0*13) (packed
separately in a plastic bag) into the inner wood plate of
closet.
In this way, the appliance will be built-in and fixed tight with
your closet.
Note: Seller should not bear responsibility for any damages
to the door or other parts during operation if the end-user does not follow this instruction to fix
the appliance with closet when needed.
Electrical connections
Warning!
the plug must remain easy to access after installation.
• The electric connections must meet the applicable standards and be capable of withstanding
the maximum power shown on the ID plate.
• The power plug must be easily accessible and out of the reach of children.
• For your safety this appliance must be earthed. If the power plug is not earthed, consult a
qualified electrician to connect your appliance in line with applicable regulations.
• Do not use extensions, adapters or multiple plugs.
• Do not place multiple plugs or portable power supply units behind the appliance.
The manufacturer declines all liability if the above mentioned safety precautions are not complied
with. If in doubt, refer to your reseller.
.
It must be possible to unplug the appliance from the mains power, so
Publicité
