Operating The Monitor - Iiyama Vision Master 1451 Mode D'emploi

OPERATING THE MONITOR

The iiyama Vision Master has been preset at the factory with the signal timings listed on page 13 in
PRESET MODES to create the best picture. If an incorrect picture appears during the operation, adjust
the image by following the procedure below to get the desired picture.
( Main Menu appears on the screen when you press the Menu Button.
B For example, to adjust the vertical position, select
on the Main Menu by using the +/– Buttons.
Adjustment icon
Adjustment menu
presently selected
The line shows the
progress of the
adjustment being
C
An adjustment scale will turn red when you press the Menu Button.
U s e t h e + / – B u t t o n s t o a d j u s t t h e v e r t i c a l p o s i t i o n . S e e
A D J U S T M E N T M E N U C O N T E N T S o n n e x t p a g e f o r f u r t h e r
information.
NOTE
n
The On Screen Display disappears several seconds after you stop pressing the buttons while
performing an adjustment. The Exit Button can be used to exit OSD window immediately.
n Any changes are automatically saved in the memory when the On Screen Display disappears.
Turning off the power should be avoided while using the Menu.
n
Adjustments for Size, Position, Pincushion, Trapezoid, Pin Balance, Parallelogram and Moire are
saved for each signal timing. Except for these adjustments, all other adjustments such as Contrast,
Brightness, Color and Rotation have only one setting which applies to all signal timings.
8 OPERATING THE MONITOR
H: 68.8KHz
made.
V: 85Hz
V-Center
70
9300
6500
(V-Center)