Siemens KI31RADD0 Notice D'utilisation page 46

en Troubleshooting
Information on display panel
Fault
Message showing "D" or "E"
appears in the display.
A warning signal sounds and
lights up.
Temperature problem
Fault
The temperature differs
greatly from the setting.
Noise
Fault
Appliance has a humming
sound.
The appliance bubbles,
buzzes or gargles.
The appliance clicks.
The appliance makes
noises.
46
Cause
The electronics have detec-
ted a fault.
Different causes are pos-
sible.
The appliance door is open.
Cause
Different causes are pos-
sible.
Cause
Not a fault. A motor is run-
ning, e.g. refrigerating unit,
fan.
Not a fault. Refrigerant flows
through the pipes.
Not a fault. Motor, switches
or solenoid valves are
switching on or off.
The appliance is not level.
Fittings wobble or stick.
Bottles or containers are
touching.
troubleshooting
Call the after-sales service.
▶
→ "Customer Service", Page 48
Press .
▶
a The alarm is switched off.
Close the appliance door.
▶
troubleshooting
Switch off the appliance.
1.
→ Page 40
Switch the appliance back on after
2.
five minutes. → Page 40
If the temperature is too
‒
warm, check the temperature
again after a couple of hours.
If the temperature is too cold,
‒
check the temperature again
on the following day.
troubleshooting
No action required.
No action required.
No action required.
Align the appliance using a spirit
▶
level. If required, place something
underneath it.
Check the removable fittings and, if
▶
required, replace these.
Move the bottles or containers
▶
away from each other.