Vonyx VMA106 Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS
1. UHF ANTENNAS
2. UHF WIRELESS STATUS
LED's showing wireless connection (RF) and audio
registration (AF).
3. VOLUME CONTROLS
Rotate to adjust the volume level for microphone A and B.
4. MUTE
Press to (un)mute the microphone input.
5. MICROPHONE/LINE/GUITAR INPUT
Balanced XLR and 6.3mm (1/4") combo input jacks for connecting microphone, musical instrument
or audio device (channel 1-4).
6. +48V PHANTOM SWITCH
This switch toggles phantom power on and off. When the switch is on the mixer supplies +48V
phantom power to that channel. Turn this switch on when using one or more phantom-powered
condenser microphones (channel 1-4).
7. LINE/INSTRUMENT
Press to switch between instrument (high impedance; guitar) and line input (low impedance).
8. HIGH AND LOW
Rotate to adjust the low- (bass) and high (treble) frequency levels.
9. FX
Rotate to adjust the volume level of the corresponding channel that is fed to the effects processor.
10. PAN
Rotate to adjust the channel signal position to left or right in the stereo mix.
11. FADER
Slide to adjust the channel volume. Pay attention to the peak LED, showing the channel status.
When the LED is illuminated, the input signal is too high. Lower the volume level immediately.
12. STEREO LINE INPUT
6.35mm stereo line input jacks (left and right).
13. STEREO LINE INPUT SENSITIVITY
Press to change the input sensitivity between +4dB and -10dB.
14. STEREO LINE INPUT BALANCE
Rotate to adjust the balance to left or right in the stereo mix.
15. STEREO LINE INPUT VOLUME
Rotate to adjust the volume level of the stereo line input.
16. FX CONTROLS
Rotate to adjust the effects parameters.
REP: Repetitions. Adjust how many times the echo repeats.
DEL: Delay. Adjust the time interval between each echo.
17. FX FADER
Slide to adjust the volume of DSP in main mix.
18. MAIN OUTPUT
XLR balanced output connectors for connecting to (for example) active speakers, power amplifiers
or other audio devices.
19. HEADPHONE OUTPUT
6.3mm jack headphone monitor output.
20. VU METER
Main output volume meter. Pay attention to the peak LED, showing the channel status. When the
LED is illuminated, the volume level is too high. Lower the main volume level immediately.
21. MP3 VOLUME
Rotate to adjust the MP3 player volume level.
22. HEADPHONE VOLUME
Rotate to adjust the headphone output volume.
23. USB
USB port interface for MP3 playback and recording.
3