Publicité
Les langues disponibles
Les langues disponibles
6. Operation
6.1 Switching bar (Fig. 1)
Switching on:
Press the switching bar (1).
:
Switching off :
Release the switching bar (1).
Important! Only activate the push sweeper when
it is positioned on the fl oor/ground; otherwise the
feed-brushes may be damaged.
6.2 Lip (Fig. 12)
For better sweeping results, the lip should be
fi tted.
The lip (16) can be removed for sweeping very
uneven surfaces to avoid tilting. To do so, undo
the two screws (16.1) as shown in Fig. 12 and
then remove the lip.
6.3 Emptying the debris collector (Fig. 13)
Warning! Dust can pose a health hazard. Wear a
breathing mask.
Warning! Wear strong gloves to protect yourself
against injury from things like fragments of glass.
Take the debris collector (8) out of the equipment
as shown in Fig. 13. Empty the debris collector
and fi t it back into the equipment again
afterwards.
6.4 Storage position (Fig. 14)
The equipment can be folded down for storage
in minimum space. To do so, loosen the quick
release levers (11) until the pins (Fig. 6, Item 3.1)
jump out of the fastener and then fold the push
bar back. The equipment can then be put in the
storage position (Fig. 14).
6.5 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.6 Battery capacity indicator (Fig. 11 / item
19)
Press the battery capacity indicator button (20).
The battery capacity indicator (19) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
Anl_TE_SW_18_610_Li_NA_SPK7.indb 13
Anl_TE_SW_18_610_Li_NA_SPK7.indb 13
EN
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
7. Cleaning and maintenance
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The penetration
of water into an electric power tool increases
the risk of an electric shock.
7.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
- 13 -
25.04.2024 09:15:38
25.04.2024 09:15:38
Publicité
