Publicité
Les langues disponibles
Les langues disponibles
Inspection Chart
NOTE: Disassemble crane, including boom and winch, periodically to inspect each for damage. Use the
following chart to determine what type of inspection is necessary. Frequent Inspection (F) and Periodic
Inspection (P).
Location
Crane
Foundation
Fasteners
(including moutning fasteners)
Handle
NOTE: Please refer to the winch owner's manual for the winch inspection chart.
Repairs
All repairs must have factory authorization. Contact OZ Lifting Products LLC ® to prevent voiding of
the two-year limited warranty and potential damage. Perform recommended inspections to identify
which parts should be replaced. Only use OZ Lifting Products LLC® replacement parts. To order
replacement parts, contact your local OZ Lifting Products LLC® dealer. Please have the serial
number, part number and a description available when calling.
Load Rating
Check For
Damage, cracks, rust, chipping, dents excess wear, or corrosion.
Unusual sounds
Smooth load movements
Equipment properly lubricated
Signs of overloading (cracks, dents, or damage)
Proper function when operated with a load equal to the load rating
Good condition/supports the crane under all conditions
Level, no swerving of boom
Cracks, corrosion, damage (check by removing crane base from foundation)
Firmly installed
Properly tightened
Stripped threads, bent, or damage (check by removing crane from foundation)
Rotates freely in both directions
*OZXR500DAV based on 3/16" Wire Rope
*OZXR1000DAV based on 1/4" Wire Rope
Load Ratings (lbs.)
OZXR500DAV
OZXR1000DAV
IMPORTANT!
rope length and diameter.
EN pg.10
1st. Layer
Mid Drum
500 lbs.
500 lbs.
1000 lbs.
875 lbs.
Load ratings will vary depending on
F
P
X
X
X
X
X
X
X
X
X
X
X
X
X
Full Drum
500 lbs.
550 lbs.
Publicité
