Assembly; Battery Charging; Operation; Starting Operation - Haussmann PT100116 Guide De L'utilisateur

ASSEMBLY

Battery Charging

Only use the battery chargers are matched to the lithium ion battery of your
power tool.
Slide the charger site towards at the battery as shown (Pic.C)
!
The Li-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the machine is switched off by
means of a protective circuit: the inserted bit no longer rotates.
WARNING! Do not continue to press the On/Off switch after the machine
!
has been automatically switched off. The battery can be damaged.
The battery is supplied partially charged. Completely charge the battery before
using your power tool for the first time. The lithium ion battery can be charged at
any time without reducing its service life. Interrupting the charging procedure does
not damage the battery.
The battery is equipped with a NTC temperature control which allows charging
only within a temperature range of between 0°C and 45°C. A long battery service
life is achieved in this manner.
Observe the notes for safe battery disposal.
Changing bits
Before any work on the machine (e.g., maintenance, tool change, etc.) as
well as during transport and storage, set the rotational direction switch to
the centre position. Unintentional actuation of the On/Off switch can lead to
injuries.
1) The drill spindle is locked when the On/Off switch is not pressed. It makes
quick, convenient and easy changing of the tool in the drill chuck possible
by pressing the On/Off switch.
2) Open the keyless chuck by turning till the tool can be inserted. Then
insert the required bit.
3) Firmly turn the collar of the keyless chuck in clockwise direction by
pressing On/Off switch. This can automatically locks the drill chuck.
4) The locking is released again to remove the bit when the collar is turned in
the opposite direction.

OPERATION

Starting Operation

Inserting the Battery
Use only original lithium ion batteries with the voltage listed on the
!
nameplate of your power tool. Using other batteries can lead to injuries and
pose a fire hazard.
19