Magnat MC 400 Mode D'emploi page 18

OPERATIONAL ELEMENTS AND CONNECTIONS - REMOTE CONTROL
1 19
18
2
17
16
15
3
14
4
13
12
5
11
6
10
9
7
8
• Before using the remote control the supplied
batteries must be inserted into the battery
compartment located at the rear of the
remote control.
• If the batteries have run out after prolonged
use, please replace them (Type 2 x AAA).
• To prevent causing damage to the remote
control please remove the batteries if the
device is not going to be used for a prolonged
period.
1 POWER
Switches the device on when it is in the standby
mode. If the LED does not illuminate, actuate the
power switch located on the rear of the device.
Conversely the device can be switched from
power operation to the standby mode.
2 INPUT SELECTON
These buttons enable direct selection of the
individual audio inputs. The active input is
indicated in the display.
3 MENU
Calls up the system menu. Use the ◄ ◄ , ► ► , ▲
and▼ buttons to navigate through the menu.
Press the SELECT button (13) to confirm the set
parameters.
See also THE MC 400'S MENU.
4 SKIP/SEARCH/NAVIGATION BUTTONS
Search/Skip backwards
• Brief press: Playback starts at the beginning of
the current track.
• Two brief presses: Playback starts at the
beginning of the previous track.
• Press and hold: High-speed rewind. Remains
active as long as the button is depressed.
(only in CD mode)
• Menu: Navigation and adjustment of
parameters.
Search/Skip forwards
• Brief press: Playback starts at the beginning of
the next track
• Press and hold: Fast forward. Remains active
as long as the button is depressed.
(only in CD mode)
• Menu: Navigation and adjustment of
parameters.
▲and▼
Menu: Adjustment of parameters.
5 DISPLAY
FM mode:
Retrieving RDS information (if supported by the
station).
Further details about the RDS station informa-
tion can be found in the "RDS functions of the
tuner" section.
DAB mode:
Retrieval of additional DAB station information
(where supported by the station).
Further details about the DAB station informa-
tion can be found in the "DAB functions of the
tuner" section.
6 TUNING
FM mode:
• Brief press: Changes the receiving frequency
in 50kHz increments (FM) (manual station
search).
• Press and hold: Searches for the next station
(automatic station search).
DAB mode:
Selects the next or previous station in the DAB
band.
18
7 NUMERICAL BUTTONS
CD mode:
Direct selection of a track.
FM mode:
Direct selection of a preset station.
8 MUTE
Switches the sound on and off.
9 DIM
This button can be used to adjust the brightness
of the display in three stages.
10 VOLUME
Increases (+) or decreases (-) the volume.
11 TONE/BAL
BASS (TONE pressed once):
Bass playback may be ramped either up or down
in 7 steps. Use the ▲and▼ buttons to adjust the
value.
TREBLE (TONE pressed twice):
The treble setting may be ramped either up or
down in 5 steps. Use the ▲and▼ buttons to
adjust the value.
BALANCE:
The stereo balance may be adjusted either to the
right or left in 20 steps. Use the ◄ ◄ and ► ►
buttons to adjust the value.
12 LOUDNESS
Selection of the Loudness function (aurally
compensated volume correction).