Publicité
Les langues disponibles
Les langues disponibles
Installation
To install Clear-Cut Flex Stock Guides on your fence, loosen both the lock
knob and the pivot knob to allow the ¼"-20 T-bolts on each guide to slide into the T-slot
on your fence. Each guide is labeled for either the infeed side or outfeed. Slide them
toward your fence guard, ensuring they can pivot up and down without hitting it.
Tighten the pivot knob on each stock guide in this position. To set each stock guide, slide
your wood under the roller of the guide and push down on the guide to reach the
desired pressure, then tighten the lock knob. Repeat for the other stock guide. To ensure
your setting will not change during routing, the lock knob on each guide can be tightened
and adjusted out of the way by pulling out the knob handle and turning it.
Publicité
