Haier 14 Serie Guide De L'utilisateur page 16

English
To replace a full width or half-width
cantilevered shelf: (see fig. # 9)
1. Guide the rear shelf hooks into the desired slots in the metal shelf
supports located on the back refrigerator wall.
2. Tilt up front of the shelf to set the shelf hooks in place.
3. Lower the front of the shelf into position until the rear hooks lock
into the slots of the metal shelf supports.
Utility Drawer and Cover
To remove the utility drawer: (see fig. # 10)
1. Slide utility drawer out until it reaches the stop.
2. Grasp front of drawer with one hand while supporting the bottom
of the drawer with the other hand. Slide drawer out gently the rest
of the way.
To remove utility drawer cover shelf: (see fig. # 11)
1. Remove utility drawer first following the above instructions.
2. Tilt up front of the shelf until the rear shelf hooks are no longer
locked in place in the rear metal shelf supports.
3. Pull the shelf gently until it is removed.
13
fig. # 9
fig. # 10