Aspire Dynamo Mod Manuel D'utilisation page 49

Using the Device
2. Under the menu item MODES you can choose between the modes „Wattage", „Voltage", „Bypass",
„CPS" (C1/C2/C3), „TC" (Ni/Ti/SS) and „TCR" (M1/M2/M3). Use the „+" and „-" buttons to navigate
through the menu, and the fire button to confirm your selection. Holding the „+" and „-" buttons
simultaneously returns you to the previous menu item. Holding down the fire button will take you to
the main interface where your current settings will be displayed.
• When the device is in wattage mode, you can adjust the value for the power output by pressing
the „+" or „-" button. Simultaneously press and hold the „+" and „-" button to select from the
predefined power settings Soft, Nor (Normal), or Hard. Use the „+" or „-" button to navigate to the
desired setting. Confirm your selection and exit the menu item by pressing the fire button.
• Once you have selected TC (Ni/Ti/SS) or TCR (M1/M2/M3) Mode, you can access the "PWR"
and "TCR" settings by pressing the "+" and "-" buttons at the same time. Press the fire button to
choose between these settings. You can now alter the calibration with the "+" and "-" buttons. You
can set the wattage between 1 W and 220 W in "PWR", while you can access the fine calibration
range between 0.20‰ and 9.99‰ in "TCR". (Note: ‰=×10
adjusted in TC (Ni/Ti/SS) Mode.
) The TCR settings cannot be
-3
47