ergoCentric UP-2L Serie Guide De L'utilisateur page 11

Step 6 :
Prepare AC cable ( G ) and handset cable ( K ).
6.1 :
Plug AC cable ( G ) into back of control box in port marked "AC".
6.2 :
Run handset wire through
the inlet hole on underside of frame
( plastic wire cover clips into inlet hole ).
There are 4 inlet hole locations
( on both sides of the frame and
at each end ). The handset installation
location will determine which inlet
should be used.
10 upCentric – UP-2L Owner's Manual | Guide de l'utilisateur
®
Step 5 :
Add plugs ( C ) into holes
on each side of the frame.
6.1