Publicité
Les langues disponibles
Les langues disponibles
4. After loading the cleaning solution into the soap bucket, tighten
the soap bucket cover to the right and insert the water inlet
connector into the pump inlet of the machine head. (Fig 4)
5. Make sure they are plugged into the power supply. (Fig 5)
6. Press the switch and the indicator light on the panel is always on.
(Fig 6)
7. Press the vacuum mode button on the head panel or remote
control handle, the machine will start to work .suction mode is
divided into high and low levels, when running in high mode,
press the vacuuming mode button switch to low mode, press the
button again and the vacuum cleaner stop working (Fig7)
8. Press the clean mode button on the head or remote control
handle, and the sprinkler head on the Water spray carpet brush
starts to spray Water. If the vacuuming mode button is pressed
again, the machine will spray Water and absorb the dirty water
after cleaning at the same time; After use, press the main power
button to shut down, then unplug the power plug, empty the
sewage in the bucket and clean the bucket for backup (Fig 8)
Operation of Blower
1. Make sure the power cord is disconnected from the power
supply. (Fig 1)
2. First press the spout button while holding the spout connector
outward, then rotate the main suction tube body to the left and
pull it outward， finally remove the hose assembly from the
vacuum cleaner. Insert the main cannula of the hose assembly
into the air outlet at the back of the head and tighten it with the
right-hand rotation. (Fig 2)
3. Insert the power cord. (Fig 3)
4. Start the switch button. (Fig 4)
5. Hold the hose assembly, let the outlet port be aimed at the
leaves, and so on. (Fig 5)
08
Installation and Disassembly Diagram of Spray
Aluminum Pipe
1. Align the water spray nozzle of the aluminum tube with the
handle spout and fit them together firmly. (Figure 1)
2. Align the two aluminum tubes with the spout and connect them
together. (Fig. 2)
3. Connect the water jet carpet brush to the aluminum tube and
insert the water inlet hose of the water jet carpet brush into the
outlet fitting of the aluminum tube. (Fig. 3)
4. Press the plastic button of the aluminum tube by hand, it can be
detached. (Figure 4)
5. Also press the plastic button by hand, both ends of the aluminum
tube can be detached. (Figure 5)
6. Pull out the water inlet pipe of the water jet carpet brush from the
aluminum tube, it can be disassembled. (Figure 6)
09
Publicité
