Assembly; Safety Instructions; Setting Up - Calira NP 3000 Mode D'emploi

Assembly

Safety instructions

Connecting the device to the power supply must comply with the applicable
national installation regulations.
The assembly and connection of electric devices should always be carried out
by qualified personnel!
Always make sure that the power supply is disconnected! Pull out the mains
plug!
Only use suitable and undamaged tools.
Only connect the device according to the supplied connection diagram!

Setting up

Remove the items packed separately (accessories) from the main carton, and
check them for completeness.
4 Fastening screws 1 Operating instructions
The device should be set up in a location not exposed to humidity and damp.
The setting up location must be clean, dry and well-ventilated. Ensure that the
ventilation slots are not covered.
Place the device as close as possible to the CEE supply socket and the 230 V
input protection.
Attach the device securely with the four fastening screws supplied.
! " # $ %& 17
Lerchenfeldstr. 9 87600 Kaufbeuren Tel.: +49(0)8341 / 9764-0 Fax: +49(0)8341 / 67806