Anslut 028930 Traduction Des Instructions D'origine page 12

● Do not use strong detergent or solvent to clean the product.
3 Installation
3.1 To install the product
1
Drill a hole where the product will be installed. (Figure 2)
2
Remove the locking nut and push the button to release the threaded pipe. Push the
the threaded pipe to the top where the push button is located. (Figure 3)
3
Put the product through the hole with the cable first. (Figure 4)
4
Attach the locking nut underneath and tighten it. (Figure 5)
5
Connect the plug to a power outlet.
3.2 To operate the product
1
Push and pull the push-button on top of the product to use it. (Figure 6)
4 Storage
● Store the product in a dry, frost-free area out of direct sunlight.
5 Maintenance
Warning! Pull out the plug form the power outlet before you do any maintenance
on the product.
● Clean the product if needed using a damp cloth.
12