Cameo F4 T Manuel D'utilisation page 7

CONFIGURING DMX MODE (DMX Mode)
Press the encoder to access the main menu. Rotate the encoder to select the menu item "DMX Mode" (left arrow) and confirm by pushing
the encoder. You can now select the desired DMX mode by rotating the encoder (5CH, 4CH, 3CH, 2CH 2, 2CH 1, 1CH). Confirm the selection
by pushing the encoder. Select the arrow symbol at the top of the menu for "back" and push the encoder to return to the main display. The
main display is activated automatically if no input is made within approximately 30 seconds. Tables with the channel assignment of the
different DMX modes can be found in these instructions under DMX CONTROL.
---------------- Menu ----------------

DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
STATIC MODE
Press the encoder to access the main menu. Rotate the encoder to select the menu item "Stand Alone" (left arrow) and confirm by pushing
the encoder. Now select the submenu item "Dimmer" and confirm by pushing the encoder and rotate the encoder to set the desired bright-
ness with values between 000 (blackout) and 255 (maximum brightness). Confirm your entry by pressing the encoder. A stroboscopic effect
can now be activated as required and set in the same way (strobe value 000 = strobe off. Value 001 = lowest flash frequency. Value 255 =
highest flash frequency). Now select the arrow symbol for "back" at the top of the submenu. Push the encoder and access the main menu in
the same way to return to the main display.
---------------- Menu ----------------

DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
SLAVE MODE
Press the encoder to access the main menu. Rotate the encoder to select the menu item "Slave" (left arrow) and confirm by pushing the
encoder. Slave mode is now enabled, and the main display is automatically displayed. Connect the slave and the master units (same model)
with a DMX cable and enable the standalone mode static on the master unit. Now the slave unit will follow the master unit.
---------------- Menu ----------------

DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
------------ DMX Mode ------------

5CH
4CH
3CH
2CH 2
2CH 1
1CH
----------- Stand Alone ----------

Dimmer <255>
Strobe <255>
Mode
Slave
DMX Address
001
000
Mode
Static
–
255
7