Publicité
Les langues disponibles
Les langues disponibles
HCS installation and operation manual
Figure 11: Mounting the SAE J1772 connector holster using the exterior wood screws and washers
Moving and storage instructions
NOTE: Both hardwired and plug-type HCS and IQ EV Charger models are intended for fixed installations. For
mounting requirements, consult the "Mounting procedures" section of the "Installation instructions" in this manual.
Always turn off input power to the EVSE at the circuit breaker panel prior to hard-wiring or disconnecting from the service
lines. Likewise, always turn off input power to the EVSE at the circuit breaker panel prior to plugging into or unplugging from
a NEMA socket.
When transporting the EVSE, do not lift or carry the entire unit by the charge cable. Likewise, do not lift or carry the entire
unit by the flexible conduit and input conductors or the NEMA plug.
The EVSE has a non-operational storage temperature range of -40°C to 80°C (-40°F to 176°F).
June 2024
140-00277-04
Figure 12: Mounting the NACS holster
© 2024 Enphase Energy Inc. All rights reserved.
25
Publicité
