Dacor EF36BNF Instructions D'installation page 6

INSTALLATION INSTRUCTIONS
IMPORTANT: If you receive a damaged product, immediately
contact your dealer or builder. Do not install or use a damaged
appliance. TO REMOVE THE DRAWER FRONT:
Door AND DRAWER FRONT REMOVAL
Some installations require door and drawer front removal before
transporting the refrigerator through doorways to the location
where it will be used. 2. Tilt the lower basket forward and
lift to remove.
A WARNING
@ 3. Loosen the four (4) screws attaching the drawer brackets to the
drawer front as shown below.
1. Pull the freezer drawer
completely open.
NOTE: Loosen the screws only three to four turns. Do not
Electric Shock Hazard remove the screws from the drawer front.
Disconnect power before removing doors.
Failure to do so can result in death or electrical shock.
TO REMOVE THE DOOR:
1. Unplug the power cord from the
power source.
2. Remove the toe
grille.
Loosen screws on both
sides of the drawer front.
! Hinge Cover
3. Remove the top hinge cover from
the refrigerator door by removing the
Phillips screw. Retain the screw and @ %
cover for later use. 4. Lift the drawer front upward and off the screws.
4. Unscrew the 5/16" hex head screws
from the top hinge. Remove the
hinge and retain it and all screws for
later use.
(=
5. On 3 door (french door) models,
disconnect the wiring plug located on
top of the left top hinge by wedging
a flat-blade screwdriver between the
two sections.
6. Lift the refrigerator door(s) from
center hinge pin.
7. Remove the Phillips screws that
hold the center hinge in place.
Remove the hinge and retain it and
all screws for later use.
Center Hinge
4 dacor