Suntek SLM4417 Manuel De L'opérateur page 9

SAFETY
INSTRUCTIONS
GENERAL
POWER TOOL
SAFETY
WARNINGS
WARNING
Read all safety
warnings, instructions,
provided with this power tool. Failure to
follow all instructions listed below may result in
Save all warnings and instructions for
future reference.
1 ) WORK AREA SAFETY
a) Keep work area clean and well lit.
b) Do not operate power tools in
explosive atmospheres, such as in
gases or dust. Power tools create sparks
c) Keep children and bystanders
away while operating a power tool.
2) Electrical safety
a) Power tool plugs must match the
outlet. Never modify the plug in any
way. Do not use any adapter plugs
with earthed (grounded) power
tools.
b) Avoid body contact with earthed or
grounded surfaces, such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric shock if
c) Do not expose power tools to rain
or wet conditions. Water entering a
power tool will increase the risk of electric
d) Do not abuse the cord. Never use
Cordless Lawn Mower
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged or
entangled cords increase the risk of electric
e) When operating a power tool
outdoors, use an extension cord
suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of
f) If operating a power tool in a
damp location is unavoidable, use
a residual current device (RCD)
protected supply. Use of an RCD
3) Personal safety
a) Stay alert, watch what you are
doing and use common sense when
operating a power tool. Do not use
a power tool while you are tired
alcohol or medication. A moment of
inattention while operating power tools may
Always wear eye protection.
Protective equipment such as a dust mask,
non-skid safety shoes, hard hat or hearing
protection used for appropriate conditions
c) Prevent unintentional starting.
Ensure the switch is in the off-
position before connecting to power
source and/or battery pack, picking
up or carrying the tool. Carrying
energising power tools that have the switch
d) Remove any adjusting key or
wrench before turning the power
tool on. A wrench or a key left attached to
a rotating part of the power tool may result in
e) Do not overreach. Keep proper
footing and balance at all times. This
enables better control of the power tool in
f) Dress properly. Do not wear loose
clothing or jewellery. Keep your
hair and clothing away from moving
parts.
g) If devices are provided for the
SLM4417
EN
9