Publicité
Les langues disponibles
Les langues disponibles
cont. installation
4.5 Installation [Air Extraction]
CAUTION
Before installation, it is important to read the information given
on the "Warning and Safety instructions" section at the
beginning of this booklet. This is particularly crucial when usin
the rangehood at the same time as a heating appliance that
relies on oxygen from the same room, which could result in the
build-up of toxic fumes.
The rangehood should be installed according to local and
national building regulations. Seek approval from the building
inspector where necessary.
The following rules must be strictly observed to
achieve optimum air extraction.
Ma
ke sure that the exhaust pipe extends as short and
straight as possible.
Do not reduce the size or restrict the exhaust pipe. When
using exhaust air pipes, always install the pipe tightly to
minimise pressure loss.
Non-compliance with these basic instructions will reduce
the performance and increase the noise level of the
rangehood.
All installation work must be carried out by an
electrician or a qualified person.
5. OPERATION
Timer
Decrease
1. Power button
1.1 Press power button one time, indicator lights of
function keys (increase,decrease,timer and lamp) will lit
on, LED display will show "0" and the hood will enter
operation mode. Press power button again,all indicator
lights of function keys will be off, and all function
operation for the hood will close. The hood enters into
standby mode and recycle like this.
2.2 After enter operation mode,if without any function
operation within 2 minutes,indicator lights of the function
keys (increase,decrease,timer and lamp) and LED display
will extinguish.
2. Timer button
5.1 The Timer button works when the motor is on only
(Press the key will be invalid when the hood is under
standby mode or open the lamp separately).
The timer setting is 5mins and could be repeat setting.
When the time is up, the cooker hood will be turn off
and the light will be off.
5.2 When the timer is set, if adjusting the speeds,
the timer function will be cancelled.
Power
Increase
CAUTION
Risk of injury! For safety reasons, only use the size of fastening or
mounting screw recommended in these operating instructions.
Non-compliance with these instructions can lead to injuries and
electric shocks.
g
NOTE
Remember that any constriction of the airflow will reduce extraction
performance and increase operating noise.
Do not connect the exhaust pipe of the rangehood to an
existing ventilation system used for another appliance,
e.g. a flue, gas pipes or hot air pipes.
In case the exhaust air pipe is bent, the angle of the
exhaust air pipe should not be less than 120°. Never
point the exhaust air pipe downwards, but always
horizontally or guide the pipe from the starting point
upwards to the air outlet on the outside wall.
After installation, please make sure that the rangehood is
positioned horizontally to prevent grease from
accumulating.
Make sure that the exhaust pipe selected for installation
complies with the relevant standards and is fire-retardant.
5.1 Control panel and function keys
Power on
After you have connected the cooker hood to the mains
supply, all the outputs will close, all indicator lights of the
buttons will lit on, and the cooker hood will enter to
standby state.
Lamp
3. Increase button
The hood has 3 speeds,they are low,middle and high.
3.1 Press Increase button one time, the indicator light of
button will be on, the cooker hood starts to work at the
low speed. the LED display will show "1".
3.2 Press Increase button again when it is working at the
low speed, the cooker hood works at the mid speed and
the LED display will show "2".
3.3 Press Increase button again when it is working at the
mid speed, the cooker hood works at the high speed and
the LED display will show "3".
3.4 When the cooker hood works at high speed, press
again, the hood will still work at high speed.
4. Decrease button
Press Decrease button, the cooker hood will decrease one
speed, and the display will show the current working speed.
When press Decreasebutton again when it is working at the
low speed, the LED display will show "0", the cooker hood
will turn off and the indicator light of theDecrease button
will change to backlight status.
5. Lamp button
Press Lamp button one time, the backlight of button and
the light will be on. Press again, the light will be off.
The indicator light of the button will change to backlight
mode and run circularly.
8
Publicité
